Tuesday, September 13, 2011

Tapered Fork - Crown Race Setter Tool

Tool Setup w/CRS-1


Section View

This Tapered Fork Crown Race Setter Tool is designed to be used in conjunction with the Park CRS-1 Driver Tube to install the headset crown race onto the fork's crown seat.   This tool is designed only to work with forks that have tapered steer tubes.

The Tapered Fork Crown Race Setter is machined from 6061-T651 Aluminum to exacting tolerances then anodized to decrease wear.

Headset Press Adapter[s] for 1 1/2 inch and Tapered Chris King Headsets


1-1/2 Headset Press Adapters

Tapered Headset Press Adapters

The Headset Press Adapter[s] are for - 1 1/2 inch and Tapered Chris King Headsets.

These Adapters are machined from 6061-T651 Aluminum billet to exacting tolerances then anodized to decrease wear.These Adapters are designed specifically to install Chris King 1 1/2 and Tapered Headsets by properly applying pressure across the top of the bearing cup assembly which eliminates bearing damage during installation.

The Adapters are compatible with the Park Headset Press (HHP-1,2,3), Pedros Headset press and Woodman.The Race Adapter is to be used when installing the base plate on the fork steer tube. The beveled side of the Race Adapter goes against the base plate before using a crown race setting tool.


Note: Frame preparation should be done in accordance to Headset Manufacture.