Wednesday, June 30, 2010

1/2" DU Bushing Tool & RWC Needle Bearing Tool

1/2" Bushing Tool w/RWC Needle Bearing Drift
This Tool is designed to remove & replace shock eyelet bushings. DU bushings are a press fit into the shock eyelets so this tool can be used in a vise, arbor press or with a soft headed hammer. Here is an illustration of the tools use http://forums.mtbr.com/showthread.php?t=396483 The RWC Needle Bearing Ejector Pin installs and removes the Needle Bearing Kit sold by Real World Cycles.


The 1/2" DU Bushing Tool and RWC Tool are machined from Stainless Steel to exacting tolerances to reduce tool wear. The 1/2" Bushing Tool will Fit shocks from Fox, Cane Creek, Romic, Marzocchi Roco, 5th Element Coil, and Rock Shox (Monarch and Vivid). The RWC Needle Bearing Ejector Pin will only fit the Real World Cycling Needle Bearing Kit.

Tuesday, June 29, 2010

A Star Fangled Nut Installation Tool


The Star Fangled Nut Installation Tool works for 1.125 inch and 1.000 inch steer tubes. The tool is machined from 6061-T651 Aluminum billet to exacting tolerances then clear anodized to reduce tool wear. There is an added Delrin pad to reduce peening from repeated installations.

Chris King and Cane Creek 110 Head Set Press Adapter


The Headset Press Adapter[s] are for - 1 1/8 inch - for Chris King and Cane Creek 110 headsets.

These Adapters are machined from 6061-T651 Aluminum billet to exacting tolerances then anodized to decrease wear.These Adapters are designed specifically to install Chris King and Cane Creek 110 headsets by properly applying pressure across the top of the bearing cup assembly which eliminates bearing damage during installation.
The Adapters are compatible with the Park Headset Press (HHP-1,2,3), Pedros Headset press and Woodman.The Race Adapter is to be used when installing the base plate on the fork steer tube. The beveled side of the Race Adapter goes against the base plate before using a crown race setting tool.

Note: Frame preparation should be done in accordance to Headset Manufacture.

Chris King and Cane Creek 110 Head Set Press Adapter

A Headset Press Adapter - 1 1/8 inch - for Chris King and Cane Creek 110 headsets.


These Adapters are machined from 6061-T651 Aluminum billet to exacting tolerances then anodized to decrease wear.These Adapters are designed specifically to install Chris King and Cane Creek 110 headsets by properly applying pressure across the top of the bearing cup assembly which eliminates bearing damage during installation.


The Adapters are compatible with the Park Headset Press (HHP-1,2,3), Pedros Headset press and Woodman.The Race Adapter is to be used when installing the base plate on the fork steer tube. The beveled side of the Race Adapter goes against the base plate before using a crown race setting tool.


Note: Frame preparation should be done in accordance to Headset Manufacture.